A New Aeration Technology Using “Supercavitation”
A newly-developed fine bubble aeration system, by which air is transferred under supercavitation conditions, shows a clearly better performance than traditional, well-known aerators that rely on the jet-pump principle (Schmid & Geier, 2003). The performance can be compared to oxygen
transfer rates achieved in membrane and foil plate aerators. A prototype supercavitation aerator installed at a sewage treatment plant revealed an air input rate, which was about one third lower than that of the replaced jet pump system. In spite of this low air input rate, the daily demand
of pure oxygen for the additionally installed membrane aeration system went down by approximately 49 percent, from the original level of about 1 200 m3/d to about 600 m3/d - and this over a test period of more than seven months. With this new aerator and during the first three months of test
phase already, more than 10 000 Euros had been saved because of the reduced pure oxygen consumption. In this article, a review of the patents on different aspects of a new aeration technology using “supercavitation” is presented.
Keywords: Mechanical aeration; energy efficiency; supercavitation
Document Type: Research Article
Publication date: November 1, 2009
- Recent Patents on Chemical Engineering publishes reviews, research articles and guest edited thematic issues on recent patents in the field of chemical engineering. A selection of important and recent patents on chemical engineering is also included in the journal. The journal is essential reading for all researchers involved in chemical engineering science.
- Editorial Board
- Information for Authors
- Subscribe to this Title
- Call for Papers
- Ingenta Connect is not responsible for the content or availability of external websites
- Access Key
- Free content
- Partial Free content
- New content
- Open access content
- Partial Open access content
- Subscribed content
- Partial Subscribed content
- Free trial content