Microstructure and mechanical properties of nickel based superalloy IN718 produced by rapid prototyping with electron beam melting (EBM)

Authors: A. Strondl, M. Palm, J. Gnauk, G. Frommeyer

Source: Materials Science and Technology

Publisher: Maney Publishing

Abstract:

A nickel alloy of a composition similar to that of the nickel based superalloy Inconel alloy 718 (IN718) was produced with the electron beam melting (EBM) process developed by Arcam AB. The microstructures of the as processed and heat treated material are similar to that of conventionally produced IN718, except that the EBM material showed some porosity and the δ phase did not dissolve during the solution heat treatment because the temperature of 1000°C apparently was too low. Mechanical testing of the layer structured material, parallel and perpendicular to the built layers, revealed sufficient strength in both directions. However, it showed only limited elongation when tested perpendicular to the built layers due to local agglomerations of pores. Otherwise, data for the hardness, Young's modulus, 0.2% yield tensile strength and ultimate tensile strength match those recommended for IN718.

Document Type:

DOI: 10.1179/026708309X12468927349451

The full text article is not available for purchase.

The publisher only permits individual articles to be downloaded by subscribers.