Formation of the Geometrically Controlled Carbon Coils by Manipulating the Additive Gas (SF6) Flow Rate
Abstract:Carbon coils could be synthesized using C2H2/H2 as source gases and SF6 as an incorporated additive gas under the thermal chemical vapor deposition system. The nickel catalyst layer deposition and then hydrogen plasma pretreatment were performed prior to the carbon coils deposition reaction. The flow rate and the injection time of SF6 varied according to the different reaction processes. Geometries of carbon coils developed from embryos to nanosized coils with increasing SF6 flow rate from 5 to 35 sccm under the short SF6 flow injection time (5 minutes) condition. The gradual development of carbon coils geometries from nanosized to microsized types could be observed with increasing SF6 flow rate under the full time (90 minutes) SF6 flow injection condition. The flow rate of SF6 for the coil-type geometry formation should be more than or at least equal to the flow rate of carbon source gas (C2H2). A longer injection time of SF6 flow would increase the size of coils diameters from nanometer to micrometer.
Document Type: Research Article
Publication date: July 1, 2012
More about this publication?
- Journal for Nanoscience and Nanotechnology (JNN) is an international and multidisciplinary peer-reviewed journal with a wide-ranging coverage, consolidating research activities in all areas of nanoscience and nanotechnology into a single and unique reference source. JNN is the first cross-disciplinary journal to publish original full research articles, rapid communications of important new scientific and technological findings, timely state-of-the-art reviews with author's photo and short biography, and current research news encompassing the fundamental and applied research in all disciplines of science, engineering and medicine.
- Editorial Board
- Information for Authors
- Subscribe to this Title
- Terms & Conditions
- ingentaconnect is not responsible for the content or availability of external websites