The Fabrication of Carbon Nanotubes Reinforced Copper Coating by a Kinetic Spray Process
In this paper, multiwalled carbon nanotubes (MWCNTs) reinforced copper coating was deposited on copper sheet through kinetic spraying process. Effect of heat treatment on microstructure, conductivity, and hardness of the coating was investigated. The incompact MWCNTs reinforced copper coating exhibits a comparable hardness, but higher electrical resistivity than pure copper coating. After heat treatment at 600 °C for 2 h, the hardness of copper coatings significantly decreased due to the substantial grain growth. MWCNTs reinforced copper coating showed stable hardness and electrical conductivity against heat treatment owing to the inhibition of CNTs to grain growth and the intimate contact between CNTs and copper matrix.
No Reference information available - sign in for access.
No Citation information available - sign in for access.
No Supplementary Data.
No Article Media
Document Type: Research Article
Publication date: 2008-10-01
More about this publication?
- Journal for Nanoscience and Nanotechnology (JNN) is an international and multidisciplinary peer-reviewed journal with a wide-ranging coverage, consolidating research activities in all areas of nanoscience and nanotechnology into a single and unique reference source. JNN is the first cross-disciplinary journal to publish original full research articles, rapid communications of important new scientific and technological findings, timely state-of-the-art reviews with author's photo and short biography, and current research news encompassing the fundamental and applied research in all disciplines of science, engineering and medicine.
- Editorial Board
- Information for Authors
- Subscribe to this Title
- Terms & Conditions
- Ingenta Connect is not responsible for the content or availability of external websites